Step 1: Warm up the engine (the engine should be warm, but not hot).
Step 2: Remove the spark-plug from the cylinder and disconnect the central wire of ignition distributor and igniter.
Step 3: For two-stroke engines fix the piston in the upper “dead” spot (in order to avoid getting the gel into the inlet and outlet windows).
Step 4: Squeeze out the tube content into the cylinder.
Note! Squeeze the content into the cylinder wall and not on the piston!!!
Step 5: Perform 15-20 piston strokes (by hand crank, towing, turning of a driving wheel etc.).
Step 6: Screw in the spark-plug and start the starter 3-4 times for 3-4 sec with the time break of 15-20 sec.
Step 7: For two-stroke engines the content of one more tube should be dissolved in 5 – 10 mi of motor oil and added into the fuel tank.
Step 8: Connect the central transmission, igniter; start the engine and operate at idle run for 15 min.
Step 9: Operate in a normal mode.
1 cylinder – 1 tube.
Gel-Revitalizant for Cylinder is designed for restoring repair and wear protection of the engine cylinder-piston group without disassembling.
Gel-Revitalixant forms cermet coating on friction surfaces of the engine cylinder-piston group.
After XADO revitalization the cylinder geometry restores, the inner diameter reduces, ellipse deformation of cylinders disappears preventing expensive overhaul.