• Restores worn surface of engine cylinders, eliminates microcracks and scratches
• Increases and levels compression in cylinders
• Protects friction surfaces against wear
• Reduces fuel consumption considerably
• Restores engine capacity up to factory values
• Increases service life of an engine by 3 times
• Decreases the level of toxic components in exhaust gases
• Decreases noise and vibration level

Application

Application instructions for engines with combined lubricating system:

• Introduce* the content of the syringe* into the petrol tank before fueling.
• Fill the tank with fuel. 
• Start the engine and let it idle for 2-3 min
• Operate the engine in normal mode

* It is recommended preliminary to dissolve the content of the syringe in a small amount of oil (20-30ml) at its temperature of exceeding +25°C.

Application instructions for engines with separate lubricating system:

• Warm up the engine to the normal operating temperature
• Empty the contents of the syringe into the oil filler neck
• Start the engine and let it idle for 2-3 min
• Operate the engine in normal mode

Note:

• The compound is equally effective for application to two- and four-stroke internal combustion engines of all brands
• Does not influence the wet clutch operation
• It is not recommended to change oil in four-stroke internal combustion engines until the end of treatment
• The treatment is considered complete after not less than 1,500 km of run (approx. 20 hours of engine operation)
• If the engine capacity exceeds 1000 cm3 it is necessary to double the dosage
• The revitalizant is compatible with any additives, metal conditioners, remetalizants irrespectively of its application sequence
• Protective ceramic-metal coating is formed on the metal surface of any alloys. If the wear rate is close to 100%, the destroyed part are subject to replacement

Pack

Syringe 4ml XA 10037