Application instructions:
-
Warm up the engine. It should be warmed but not hot
-
Unscrew the spark plugs. Disconnect ignition timing sensor, Hall device and commutator
-
Spray the content (for 5 sec) into each cylinder alternately through a nozzle hose. Screw the plugs back in. Wait for 10-20 minutes. Unscrew the plugs. Cover the plug holes with absorbing fabric to avoid dirt flying-out and getting onto the paint. Rotate the engine with the starter for several seconds
-
Place the spark plugs into their position
-
Start the engine and run it at moderate rpm for up to 15 minutes. During this period softened remains of carbon will be removed through the exhaust system
Note:
-
Avoid getting the substance onto lacquer coatings!
-
Safe for catalyst converters, oxygen sensors, mechanical rubber parts and sealings.
-
Restores mobility of stuck piston rings
-
Reduces oil consumption
-
Cleans cylinders and pistons, combustion chambers and valves from any kind of contamination (scale, carbon, varnish, tar)
-
Equalizers compression in cylinders
-
Decreases noise while engine operating
-
Removes deposits from spark-plugs
-
Reduces exhaust level into the atmosphere
Cleaning piston rings from carbon
Fast-acting product designed to remove carbon contaminations and restore stuck piston rings of gasoline and diesel engines. Removes all scale and tar contaminations from parts surfaces of cylinder-piston group. It does not require oil change after application.
